Lightburn GCode Inverts Light and Dark on Photos - Snapmaker 2.0
Por um escritor misterioso
Descrição
I have a photo that I have dithered using imag-r.com using Norton tile method. Everything looks great in Lightburn using Threshold but when gcode runs on SM2, it prints as if inverted has been selected which is hasn’t. It also prints this way on the Lightburn dither options with the exception of grayscale at S-Value 254. @brent113…you have a lot of Lightburn experience. Have you seen this before? I started with LB 9.20 and have bumped down to 9.13. I am on SM2 firmware version 1.9.0. I have look
Firmware request: Tool Change Mode with enclosure lights left ON - #21 by brent113 - Snapmaker 2.0 - Snapmaker: where creation happens
Firmware request: Tool Change Mode with enclosure lights left ON - #22 by MooseJuice - Snapmaker 2.0 - Snapmaker: where creation happens
Fiber Laser Test
Confused by output of Inverted Image - LightBurn Software Questions - LightBurn Software Forum
Laser Pause While Changing Power - Snapmaker 2.0 - Snapmaker: where creation happens
Snapmaker 2.0: edges burn darker on fill, regardless of overscan setting and fast whitespace scan setting - LightBurn Hardware Compatibility - LightBurn Software Forum
Inverting an Image - LightBurn Software Questions - LightBurn Software Forum
3D Printer Laser Modification : 19 Steps (with Pictures) - Instructables
Fiber Laser Test
de
por adulto (o preço varia de acordo com o tamanho do grupo)
