Pre-printing 3 dabs - 3D Fabrication - Dallas Makerspace Talk
Por um escritor misterioso
Descrição
I’m sure most of you have watched the polyprinters start a print. They begin by preheating the extruder and then go to the front left corner of the bed to deposit 3 little dots to prime the extruder. My question is: Is this part of the G-code pre-processor script, or is it a function of the KISSlicer software? I’d like to do something similar for my Ender 3 and using PrusaSlicer, but I’m lazy and don’t want to figure out how to do it myself. 🙂 @frank_lima @AndrewLeCody
The State of 3D Printing and Scanning After CES 2014: The Push For Mainstreaming Begins - Make
UPDATED April 2nd - From Design to Mass 3D printing of Medical Shields in Three Days - Original Prusa 3D Printers
Dallas Makerspace Talk
Dallas Makerspace Talk
Makerspace - Hours
EHS The Magazine: Spring 2023 by Episcopal High School - Issuu
Foothills Community Workshop A Hackerspace/Makerspace for the NC Foothills
Research & Insights: Search
Happenings — UnSmoke Systems Artspace
3D Printing a Culture Change on the Factory Floor
UPDATED April 2nd - From Design to Mass 3D printing of Medical Shields in Three Days - Original Prusa 3D Printers
Sponsors of upcoming 3D printing show expect 400-plus companies to exhibit
Form 2 is here! - 3D Fabrication - Dallas Makerspace Talk
de
por adulto (o preço varia de acordo com o tamanho do grupo)
